Operator's Manual

1.56

Regularly check that the cutterblade securing bolts (items 1 and 2) are tightened to the

specified torque and re-new cutterbar - lock tabs.

Bolt (item 1) - Torque to 70-95Nm.

Bolt (item 2) - Torque to 40-55Nm.

Ensure that each cutterblade is balanced. Use a screw driver with a round shaft to sup-

port the cutterblade through its centre hole. Hold the cutterblade horizontal and then

release. A balanced cutterblade will remain horizontal. If the cutterblade is not bal-

anced the heavy end will rotate downwards. Regrind the heavy end until the cutterblade

is correctly balanced.

MAINTENANCE

CS026

CS025

CUTTERBLADES

1. Bolt - Motor

2. Bolt - Cutterblade

3. Locating Ring

4. Cutterblade Mounting

5. Key - Motor

6. Cutterblade - Lock Tab

4D994C01A