Operator's Manual

4
Installation
Check the position of the recoil start on the engine
being replaced. Note that this replacement engine is
assembled for zone-start blade applications.
Starter Rope Configuration for
Zone-start Applications
1. Insert the starter rope into the rope guide
(Fig. 3).
2
m–2705
1
Figure 3
1. Rope Guide (typical) 2. Starter Rope
2. Fasten the rope stop to the starter rope to within
2-1/2” (64 mm) of the recoil assembly.
Starter Rope Configuration for
Non-zone-start Applications
1. Remove the recoil assembly (Fig 4).
2. Rotate the recoil assembly 90 degrees clockwise,
then reassemble the recoil assembly to the
engine (Fig 4).
1
Figure 4
1. Recoil Assembly
3. Remove the rope stop and starter handle from
the starter rope.
4. Remove approximately 28” (71 cm) of the starter
rope, then reattach the starter handle.
5. Attach the recoil decal to the recoil assembly so
the decal reads from the front of the engine.