Service Manual

OUTPUT SHAFT
Lift both the output and the drive shaft assemblies
out of the bottom case half (Fig.
10).
‘.-
FIG. 10. Lift Shafts from Case Half
Work the chain
off of the two sprockets and sep-
arate the shaft assemblies (Fig.
11).
FIG. 11. Output Shaft Assembly
All parts of the output shaft assembly are slip fits.
The gears and sprockets are keyed to the shaft. Re-
move the “E” ring and the snap ring from the ends
of the shaft and disassemble,
The shim washers
should be identified
so they can be returned to their
original positions to simplify adjusting output shaft
end play (Fig.
12).
DRIVE SHAFT
The components of the drive shaft assembly are
also slip fits. There are two snap rings
on the drive
shaft to keep the bevel gear and the drive shaft in
proper position(Fig. 13).
FIG. 12. Output Shaft Disassembled
SNAP
FIG. 13. Drive Shaft Assembly
Remove the component parts and snap rings from
the drive shaft. Shim washers are located at the 3rd
gear end of
the drive shaft, and normally on both
sides of the bevel gear. The shim washers should be
identified
so they can be returned to their original
positions during reassembly.
-3-
FIG. 14. Drive Shaft Disassembled