Service Manual

FIG. 5. Align Detent Pins
FIG.
6. Replace Nylon Cover
Check the two leads for continuity with the trans-
mission in the neutral position. Continuity should
exist with the transmission in neutral only. Reconnect
the switch wiring and test for proper operation with
the transmission in each gear. Starting the engine
should only be possible with the shift lever in neutral.
OVERHAUL
DiSASSEMBLY
Remove the transmission from the vehicle and re-
move the input shaft pulley.
SHIFT FORKS
Remove the nylon top plate and interlock switch
components as described under "INTERLOCK SWITCH".
Remove the shift lever nylon seat and wave washer.
Note that the nylon seat
is recessed at the top to ac-
commodate the ball on the shift lever. Turn the trans-
mission over
so the detent springs and detent balls
fall out of their bores (Fig.
7).
FIG. 7. Shift Control Components
Remove
the eight hex bolts (1/4-20 x 1 5/16 that hold
the two case halves together. Lift the top case from
the bottom case (Fig.
8).
FIG. 8. Separate Case Halves
The shift forks are held in place by four Phillips
head shoulder screws. Remove the four screws. Re-
move the lockout plate and the two shift forks. The
shift forks are different, and their mounting positions
should be noted during removal (Fig.
9).
FIG. 9. Shift Forks and Lockout Plate
-2-