Operator's Manual

3
3. Inspect the Hedge Trimmer cutting blades and
guide. Replace any parts that are cracked,
chipped or damaged before using the Hedge
Trimmer. Refer to Adjusting the Cutting Blades
on page 7.
4. Never use replacement parts that are not
approved by Toro.
5. Maintain the Hedge Trimmer according to the
recommended maintenance intervals and
procedures in the Maintenance section on
page 9.
6. If running problems or excessive vibration occur,
stop immediately and inspect the unit for the
cause. If the cause cannot be determined or is
beyond your ability to correct, return the Hedge
Trimmer to your servicing dealer for repair.
Fuel Safety
1. Gasoline is highly flammable and must be
handled and stored carefully. Use a container
approved for fuel for storing gasoline and/or
fuel/oil mixture.
2. Mix and pour fuel outdoors and where there are
no sparks or flames.
3. Do not smoke near fuel or the Hedge Trimmer,
or while using the Hedge Trimmer.
4. Do not overfill the fuel tank. Stop filling 1/4–1/2
inch (6mm–13mm) from the top of the tank.
5. Wipe up any spilled fuel before starting the
engine.
6. Move the Trimmer at least 10 feet (3 m) away
from the fueling location before starting the
engine (Fig. 3).
7. Do not remove the Trimmer fuel tank cap while
the engine is running, or right after stopping the
engine.
8. Allow the engine to cool before refueling.
9. Drain the tank and run the engine dry before
storing the unit.
10. Store fuel and the Hedge Trimmer away from
open flame, sparks and excessive heat. Make
sure fuel vapors cannot reach sparks or open
flames from water heaters, furnaces, electric
motors, etc.
Power Hedge Trimmer
Operating Safety
1. THIS HEDGE TRIMMER CAN CAUSE
SERIOUS INJURIES. Read the instructions
carefully. Be familiar with all controls and the
proper use of the Hedge Trimmer.
2. Never allow children to operate the Trimmer.
3. Keep the area of operation clear of all persons,
particularly small children and pets.
4. The Trimmer blades are extremely sharp. Do not
put hands or feet near or under any moving parts.
Keep your body clear of the blades at all times.
5. Always keep the protective cover over the sharp
edges of the blades when the Trimmer is not
being used.
6. Use the Trimmer only in daylight or good
artificial light.
7. Inspect your work area before you begin.
Remove string, rope or similar materials which
can become entangled in the Trimmer blades.
8. Avoid hidden hazards. Watch for hidden objects
within your working area such as chain link
fences, cables, wires, telephone and power lines.
9. Never operate the Trimmer without proper
guards or other protective safety devices in
place.
10. Keep firm footing and balance. Do not
overreach. Do not operate the Trimmer while
standing on a ladder or similar temporary
support.
11. Use the right tool for the job. Do not use the
Trimmer for any job that is not recommended by
Toro.