Operator's Manual
14
Operation
Operation
Fueling and Refueling the Trimmer
WARNING:
Gasoline and its vapors are highly ammable
and explosive. To prevent serious personal
injury and property damage, handle it with care.
Keep away from ignition sources and open
ames, handle outdoors only, do not smoke and
wipe up spills immediately.
Fuel Mixture
This product is powered by a 2-cycle engine and requires
pre-mixing gasoline and 2-cycle lubricant. Pre-mix unleaded
gasoline and 2-cycle engine lubricant in a clean container
approved for gasoline. DO NOT mix quantities larger than
usable in a 30-day period.
WARNING:
Do not allow familiarity with this product to
make you careless. Remember that a careless
fraction of a second is sufcient to inict
serious injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1, along with
hearing protection. Failure to do so could result
in objects being thrown into your eyes and other
possible serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool.
The use of attachments or accessories not rec-
ommended can result in serious personal injury.
WARNING:
Operation of this equipment may create sparks
that can start res around dry vegetation.
A spark arrestor may be required. The op-
erator should contact local re agencies for
laws or regulations relating to re prevention
requirements.
Applications
Use this product for the following applications:
■ Cutting grass, weeds, and light undergrowth
■ Edging along sidewalks and driveways
Recommended fuel: This engine is certied to operate on
unleaded gasoline intended for automotive use.
Note: We recommend you use PowerCare 2-cycle lubricant
(6.4 oz. or 16 oz.) or an equivalent high-quality synthetic
2-cycle lubricant in this product. Mix at 2.6 oz. per gallon
(US).
Do not use automotive lubricant or 2-cycle outboard
lubricant.
HIGH QUALITY 2-CYCLE ENGINE LUBRICANT
GASOLINE LUBRICANT
1.0 gal. (US) (3.8 liter) 2.6 oz. (76 ml)
2.5 gal. (US) (9.5 liter) 6.4 oz. (189 ml)
Filling Tank
■ Clean surface around fuel cap to prevent contamination.
■ Loosen fuel cap slowly by turning counterclockwise. Rest
the cap on a clean surface.
■ Carefully pour fuel into the tank. Avoid spillage.
■ Prior to replacing the fuel cap, clean and inspect the
gasket.
■ Immediately replace fuel cap and hand tighten by turning
clockwise. Wipe up any fuel spillage.
■ Move at least 30 ft. away from refueling area before starting
the product.
Note: It is normal for smoke to be emitted from a new
engine after rst use.
WARNING:
Always shut off engine before fueling. Never
add fuel to a machine with a running or hot
engine. Move at least 30 ft. from refueling site
before starting engine. Do not smoke and stay
away from open ames and sparks. Failure to
safely handle fuel could result in serious per-
sonal injury.
Oxygenated Fuels
DO NOT USE E85 FUEL. IT WILL VOID YOUR WAR-
RANTY.
Note: Fuel system damage or performance problems result-
ing from the use of an oxygenated fuel containing more than
the percentages of oxygenates stated below are not covered
under warranty.
Ethanol. Gasoline containing up to 10% ethanol by volume
(commonly referred to as E10) is acceptable. E85 is not.