Operator's Manual

Operation 17
Starting the Product
See Figure 14a, Figure 14b, and Figure 15.
Starting the product differs depending on whether the
engine is cold or warm. Refer to the label on the air filter
cover.
To Start a Cold Engine
Follow these steps to start a cold engine.
1. Lay the product on a flat, bare surface.
2. Toggle the switch to the I (ON) position.
3. Push the primer bulb approximately eight times.
4. Set the choke lever to A (Choke Closed).
5. Press the lock-off button and squeeze the trigger.
6. Pull the starter cord three times.
7. Set the choke lever to B (Choke Open).
8. Press the lock-off button and squeeze the trigger.
9. Pull the starter cord.
Note: If the product starts, let it run for 30 seconds
before using it. If the product does not start, repeat
the previous steps.
Figure 14a
Figure 14b
To Start a Warm Engine
Follow these steps to start a warm engine.
1. Lay the product on a flat, bare surface.
2. Toggle the switch to the I (ON) position.
3. Push the primer bulb up to eight times.
4. Set the choke lever to B (Choke Open).
5. Do not squeeze the trigger.
6. Pull the starter cord.
Note: If the product does not start, repeat the previ-
ous steps.
Stopping the Product
See Figure 15.
Follow these steps to stop the product.
1. Release the trigger.
2. Toggle the switch to the O (OFF) position.
Figure 15
WARNING:
The product may throw objects during
operation, causing injury to the operator or to
bystanders. Always wear suitable eye protection,
long heavy pants, and boots while operating the
product.
Bulb
Primer
Lock-off
Button
Trigger
Starter
Cord
Switch
Set Choke to A
Set Choke to B
Switch
Trigger