Service Manual

Reassembly
1. Install the starter spring into the starter housing
as follows:
a. Orient the replacement starter spring so the
spring windings are clockwise (the open end
of spring hook is to the left).
b. Grasp the spring near the spring hook with a
needle-nose pliers and carefully remove the
spring retainer.
c. Place the spring into the starter housing.
Make sure the spring hook is installed over
the post in the starter housing.
d. Make sure the spring windings are laying flat
against the starter housing around the entire
circumference of the spring. Hold the spring
in this position and carefully release the
needle-nose pliers holding the spring.
2.6071.059
2.6071.057
2.6071.058
MAJOR COMPONENTS (cont.)
3
DISASSEMBLY, INSPECTION, & REPAIR
3 - 25