Service Manual

9. Install the pulley retainer and screw. Torque the
screws to 20-30 in•lb (2.3-3.4 N•m).
10. Pull the rope out to its full length and let it return.
Check the spring tension and adjust as
necessary. Refer to “Adding Starter Spring
Tension” above.
Remove Ignition Module
1. Make sure the spark plug wire and the lead
wires to the ignition module are disconnected.
2. Remove the screws securing the ignition module
to the cylinder. Remove the ignition module.
Remove Flywheel
WARNING: CRACKED OR BROKEN COOLING
FINS ARE A HAZARD!
Be careful not to crack or break any cooling fins.
They could fly off during operation. If cooling fins are
cracked or broken, replace the flywheel.
1. Using a plastic-faced mallet, tap and pull
flywheel until it breaks free from the crankshaft.
2.6071.065
2.6071.053
2.6071.064
ENGINE
MAJOR COMPONENTS (cont.)
3
DISASSEMBLY, INSPECTION, & REPAIR
3 - 27