Service Manual

2. Insert the rope through the hole in starter pulley.
Tie a single knot in the rope approximately
0.5 in. (12.7 mm) from the end.
3. Pull the rope tight, pulling the knot into the pocket
in the pulley. Using a screwdriver, or similar tool,
push the end of the rope into the slot in the
pulley.
4. Hold the pulley with the pawl engagement teeth
towards you. Wrap the rope around the pulley in
the clockwise direction. Make sure all of the
rope is wound onto the pulley.
5. Apply a small amount of grease (Mobilgrease®
HP or equivalent) to the post in starter housing,
spring, and backside of pulley.
6. Install the rope guide bushing into the starter
housing.
7. Install the pulley/rope assembly into the starter
housing. Rotate the pulley slightly until the
spring hooks onto the pulley, and the pulley
drops into place.
8. Route rope through the guide bushing in the
starter housing.
Install the pull handle on the rope and secure it
with a single knot.
2.6071.062
2.6071.060
2.6071.056
Post
MAJOR COMPONENTS (cont.)
3
DISASSEMBLY, INSPECTION, & REPAIR
3 - 26