Service Manual

2. Remove the flywheel from the crankshaft.

3. Remove the flywheel key from crankshaft.

Flywheel Inspection and Repair

Inspect the flywheel for the following conditions:

• Missing, broken, or cracked fins.

• Oval shaped pawl pin holes.

• Broken, damaged or missing springs, pawls, or

pawl pins. Freedom of movement of pawls.

• Evidence that the Starter Pawl Repair Kit has

been installed (holes in bottom of the flywheel

below pawl pins).

• Other signs of fatigue, wear, or damage to the

flywheel.

Starter Pawl Repair Kit, P/N 180142, is available to

repair the flywheel. This kit contains 2 pawl pins

(oversized*), 2 pawl springs, and 2 pawls. To install

the kit, an arbor press, 0.228 in (5.79 mm) drill and

drill press are required. Installation instructions are

provided in the kit.

*NOTE: The pawl pins in this kit are oversized.

Once this kit is installed, the flywheel cannot be

repaired a second time.

For all other damage, replace the flywheel.

2.6078.093

2.6071.066

2.6060.161

CONTENTS OF KIT

#180142

2 Starter Pawl Pins

(oversized)

2 Starter Pawl Springs

2 Starter Pawls

ENGINE (cont.)

DISASSEMBLY, INSPECTION, & REPAIR

3 - 28