Service Manual
Push Button Switch
1. Remove the screw and washer securing the
switch into the styling cover.
2. Pull the switch out of the styling cover from the
back. The push button cap will come off of the
switch as it is removed.
3. Reassemble the switch in the reverse order of
disassembly.
Starter Disassembly, Repair, And Reassembly
WARNING: Spring under tension!
The rope starter on these engines contains a flat wire
spring that is under tension. eye and hand
protection when replacing worn or broken spring, in
case it should uncoil as it is handled. Allow spring
tension to be completely relieved and make sure
pulley disengages from spring before removing the
pulley retainer(s), pulley, and starter spring from
housing.
Adding Starter Spring Tension
If the rope pull handle does not fully return against
the starter housing, the spring may need another turn
of tension. Additional tension can be added without
disassembling the starter.
To add spring tension:
1. Pull the rope out a short distance and hold the
pulley from turning.
2. Wind one or more extra turns of rope onto the
pulley.
DISASSEMBLE MAJOR
COMPONENTS (cont.)
2.6089.072
3.6089.071
2.6060.153
3
DISASSEMBLY, INSPECTION, & REPAIR
3-34