Service Manual

Final Carburetor Adjustment

Make final adjustments to the carburetor when the

unit is fully reassembled. Refer to “Carburetor Adjust-

ment” in Part 1 — General Information.

Remove Carburetor Mount/Reed Plate And Fuel

Tank

Trimmers And Cultivators

1. Remove the four screws securing the

carburetor mount/reed plate to the

crankcase.

2. Remove the carburetor mount/reed plate and car-

buretor mount/reed plate gasket.

3. Remove the fuel tank (held in place by the

carburetor mount/reed plate).

Blowers And Blower/Vacs

The fuel tank on blowers and blower/vacs is held in

place by the engine side covers. Remove the engine

side covers to remove the fuel tank.

Remove the carburetor mount/reed plate as follows:

Models 280, 300BV, 310, And 310BV

1. Remove the four screws securing the carburetor

mount/reed plate to the crankcase .

2. Remove the carburetor mount/reed plate and car-

buretor mount/reed plate gasket.

DISASSEMBLE MAJOR

COMPONENTS (cont.)

2.6081.046

2.6081.045

3.6069.010

(L) Idle

Mixture Needle

(H) High Speed

Mixture Needle

Idle Speed

DISASSEMBLY, INSPECTION, & REPAIR

3-22