Service Manual

3. Remove the fuel metering diaphragm and
gasket.
4. Remove the screw securing the metering lever
hinge pin in carburetor body.
Remove the metering lever, hinge pin, metering
lever spring, and fuel inlet needle.
NOTE: These components are under spring
tension. Remove them carefully to prevent loss.
Make sure the spring is not stretched.
Fuel Pump Side
1. If necessary, remove the idle speed adjusting
screw and spring from fuel pump cover.
2. Remove the fuel pump cover screw and cover.
DISASSEMBLE MAJOR
COMPONENTS (cont.)
2.6081.034
2.6081.036
2.6081.035
3
DISASSEMBLY, INSPECTION, & REPAIR
3-17