Service Manual

Typical Assembly Sequence

The following sequence is suggested for complete

engine reassembly. This procedure assumes that all

components are new or have been reconditioned, and

all component subassembly work has been

completed. This procedure can be varied to

accommodate individual requirements for assembly

and repair.

NOTE: Make sure the engine is assembled using all

specified torque values and clearances. Failure to

observe specifications can cause severe engine wear

or damage.

Always use new gaskets.

1. Install Piston/Connecting Rod And Cylinder

To Crankcase, Install Spark Plug

2. Install Fan Shroud

3. Install Flywheel

4. Install Ignition Module

5. Install Starter Housing

6. Install Clutch

7. Install Muffler

8. Install Fuel Tank And Carburetor

Mount/Reed Plate

9. Install Carburetor And Choke,

Connect Fuel Lines

10. Install Air Filter

11. Install Styling Cover

12. Install Engine Into Equipment

13. Prepare The Unit For Operation

* On some units, these can be removed and reinstalled

without removing the engine from its normal operating

installation.

REASSEMBLY

4-4