Service Manual

NOTE: If necessary, loosen the pulley re-
tainer(s) screw(s) while holding the pulley down
to provide clearance between the retainer(s)
and pulley. Torque the retainer(s) screw(s) to 20-
30 in•lb (2.3-3.4 N•m) after additional rope is
wound onto pulley.
3. Pull the rope out to its full length and let it
return until the pull handle rests against the
starter housing.
NOTE: Do not add any more tension than is
necessary to make the pull handle return
against the starter housing. Adding excessive
spring tension can cause the spring to break.
If spring pressure is weak, and adjustment will
not enable the pull handle to return against the
starter housing
, replace the spring.
Starter Disassembly
1. Relieve the spring tension by removing the
pull handle and allowing the pulley to slowly
unwind inside the starter housing. Make
sure the spring tension is fully relieved
before proceeding.
2. Remove screw(s) and pulley retainer(s)
DISASSEMBLE MAJOR
COMPONENTS (cont.)
2.6089.073
2.6089.082
2.6090.135
3
DISASSEMBLY, INSPECTION, & REPAIR
3-35