Service Manual
1100
8
&
1
1
VALVE
10492
VALVE
i
RELIEF
VALVE
FIG. 11.
VICTOR Control Valves
(Eaton Transmission)
TTACHMENT
YL. BASE END
ATTACHMENT
BASE END
ATTACHMENT
CYL.
ROD
END
TPH CYL.
BASE END
ATTACHMENT
CYL. ROD EN
io
TRANS. TRANS.
FIG. 12.
VICTOR Valve
Port
Identification
OVERHAUL
KIT
CONTENTS (VICTOR)
VICTOR
1
10068
&
1
1 1066
Control Valves
The
109081
Overhaul Kit for VICTOR control valves
contains the parts listed below.
ITEM
QTY.
DESCRIPTION
1
2
2
1
3
1
4
1
5
1
6
1
7
1
8
1
9
1
10
1
O-ring,
Spool
Valve
Washer (Under Return Spring)
Spool Return Spring
Spool Retainer Cap
Snap Ring
Washer (Under
7)
Screw,
Spool
Retainer
Ball (Relief Valve)
Spring, White (Relief Valve)
Gasket,
Relief
Valve Cap
Except for the valve handle, handle link, clevis
pin and cotter pins, no other repair parts are avail-
\
able.
The
valve must be replaced
if
the overhaul kit
fails to correct the problem.
VICTOR
1
10492
Control Valve
Tho
109097
Overhaul Kit for VICTOR control valves
contains the parts listed below.
ITEM
QTY.
DESCRIPTION
1
2
2
4
3
4
4
1
5
2
6
3
7
1
8
1
9
1
10
1
11
1
12
2
13
2
14
1
15
1
16
2
17
1
"O"
Ring
-
Load Check Plug
"O"
Ring
-
Spool
Screw With Lockwasher
Spacer Screw
Steel
Ball
-
Detent
Washer
Spacer
-
Spool w/o Detent
Return Spring
-
Spool w/o Detent
Return Spring
-
Spool With Detent
Detent Spacer Screw
Spacer
-
Spool With Detent
Spring
-
Load
Check
Valve
Spring
-
Detent
Spring
-
Relief Valve
Ball Retainer
Gasket
-
Relief Valve
Steel
Ball
-
Relief Valve
Except for the valve handle, handle link, clevis pin
and cotter
pins,
no other repair parts are available.
The valve must be replaced if the overhaul kit fails
to solve the problem.
OVERHAUL PROCEDURE (VICTOR)
Service
Notes
1.
Use
a clean, dirt-free work surface and clean
2.
lubricate spool valve O-rings and spool valve
solvent to prevent system contamination.
with oil when reassembling.
Disassembly
&
Reassembly
(SINGLE
SPOOL
VICTOR)
1.
Remove the snap ring from
the
spool retainer
cap (Fig.
13).
2.
Remove the screw and washer from the retainer
cap and remove the cap, spring and washer.
3.
Remove the clevis pin from
the
handle and
remove the handle and handle link (Fig.
14).
4.
Pull the spool out of the valve body. Remove
and discard
the
O-rings.
FIG.
14.
Remove Handle and
Spool
4-
RETAINER CAP
SCREW
&
WASHER
SNAP RING
SPRING
FIG.
13.
Remove Retainer Cap and Return Spring