Operator's Manual

Page 18 Setup Instructions
Figure 7: Installing an option / removing an option
A. Rear of MH-400
B. Option attachment bracket
C. Lock pin
D. Lock ring
E. Safety latch clip
F. Clamp handle
G. Safety latch
H. Option
I. Lift
J. Pull
K. Rear clamp assembly
L. Note – Support option before removing clamps
How to Connect the Option’s Hydraulics
WARNING: Ensure that the tow vehicle
is turned off before making connections,
to prevent the option from accidentally
turning on.
To connect the hydraulic hoses to the option control
valve on the MH-400 fender:
1. Pull back (or push forward) on the outer sleeve of the
female connector and insert the male connector.
2. Hold the male connector firmly in place and release
the outer sleeve of the female connector.
3. Ensure that the connectors are pushed all the way in
and are securely locked in place.
4. With the tow vehicle hydraulics operating, pull back
on the option control lever, and ensure that the
option is operating properly.