Service Manual

Multi Pro 5800Page 6 − 100Electrical System

Electric Hose Reel Motor Switch (Optional)

The electric hose reel kit motor switch is a momentary

push button switch used to energize the hose reel relay.

The hose reel switch is located on the hose reel control

box (Fig. 151).

Testing

1. Park machine on a level surface, stop engine and en-

gage parking brake. Remove key from ignition switch.

2. Remove the hose reel control box from the reel

mount. Locate hose reel switch and unplug wire harness

connector from switch.

3. With the use of a multimeter (ohms setting), electric

hose reel kit switch functions may be tested to determine

whether continuity exists across the terminals for each

switch position. Continuity (zero ohms resistance)

should exist across the switch terminals when the switch

is depressed. There should not be continuity (infinite

ohms resistance) across the switch terminals when the

switch is not depressed.

4. Replace switch if testing determines that it is faulty.

5. If the switch tests correctly and a circuit problem still

exists, check wire harness (see Electrical Schematic

and Wire Harness Drawings in Appendix A − Foldout

Drawings in this manual).

6. Connect the wire harness connector to the switch

and install the hose reel control box after testing is com-

plete.

1. Hose reel control box 2. Hose reel motor switch

Figure 151