Service Manual

Multi Pro 5800 Page 8 − 43 GeoLink Spray System
Problem
Possible Cause Corrective Action
The speed is not showing when
moving
The compass is not calibrated
The receiver is lacking satellite re-
ception
The vehicle ground speed is less
than 1.1 km/h (0.7 mph)
Calibrate the compass
Drive away from reception obstruc-
tions and allow time for the receiv-
er to connect to the satellites
Increase the speed above 1.1 km/
h (0.7 mph)
There is condensation inside the
display
The display warms up too quickly
in direct sunlight with the display at
100 percent brightness
The receiver is lacking satellite re-
ception
The vehicle ground speed is less
than 1.1 km/h (0.7 mph)
Change the screen brightness to
85 percent and allow the display to
warm up
Drive away from reception obstruc-
tions and allow time for the receiv-
er to connect to the satellites
Increase the speed above 1.1 km/
h (0.7 mph)
Operator Advisories (InfoCenter Display)
If one or more Toro Electronic Controller (TEC) inputs
are not in the correct position to allow certain machine
operations, or are malfunctioning, an audio alarm will
sound and an Operator advisory will appear on the Info-
Center Display (Fig. 50). Typically, an advisory can be
eliminated with a change in machine controls by the op-
erator. For example, if the operator attempts to start the
engine when the traction pedal is depressed, an adviso-
ry is identified on the InfoCenter Display that the traction
pedal needs to be in neutral. The advisory screen will
clear automatically after a few seconds or can be
cleared from the display manually by pressing any of the
InfoCenter buttons. An advisory will not be recorded in
any fault log. See Chapter 6 − Electrical System in this
manual or the machine Operator’s Manual for the com-
plete list of operator’s advisories. The following table ex-
plains each spray system operator advisory specific to
machines with GeoLink spray systems.
1. Advisory number/code 2. Advisory description
Figure 50
1
2
PRESS ANY KEY
TO START PUMP
TURN BOOMS OFF
202
Advisory Advisory Description Recommended Action
202 Pump start prevented − Boom active Set master boom switch to OFF
position
203 Pump Start Prevented −
Operator out of seat and parking brake not engaged
Operator return to seat or set parking
brake
205 Pump Start Prevented − Engine starting Set spray pump enable switch to OFF
position
206 Pump Turned OFF − Operator not in seat Operator return to seat or set parking
brake
403 Rinse Pump ON (optional clean tank rinse kit) Set optional clean tank rinse pump
switch to OFF position