Service Manual

Multi Pro 5800 Page 8 − 3 GeoLink Spray System
General Information
User Manuals
A variety or User Manuals are available for Multi Pro ma-
chines with GeoLink spray systems. The Operator’s
Manual, Interactive Manual, Quick Start Guide, Installa-
tion Instructions and Parts Catalogs provide information
regarding the installation, operation, general mainte-
nance and maintenance intervals for your Multi Pro ma-
chine. Refer to these publications for additional
information when servicing the machine.
GeoLink Spray System Service and Support
Unlike other Toro commercial products, the first call for
assistance with your Multi Pro 5800 with optional
GeoLink Spray System should be the Toro National
Support Network (NSN) and not your Authorized Toro
Distributor. The people at NSN configured and tested
the GeoLink components on your machine prior to
installation, and are best suited to help diagnose
GeoLink spray system issues quickly. Contact NSN at
1−844−GEOLINK (436−5465) or [e-mail].
Precautions Concerning Chemicals Used in Spray System
Chemicals can injure persons, animals, plants, soil or
other property. To reduce the risk of environmental dam-
age and personal injury:
1. Select the proper chemical for the job.
2. Carefully read the directions printed on the chemical
manufacturer’s labels before handling chemicals. In-
structions on chemical manufacturer’s container labels
regarding mixing proportions should be read and strictly
followed.
3. Keep spray material away from skin. If spray material
comes in contact with a person, wash it off immediately
in accordance with manufacturer’s recommendations
(container labels and Material Safety Data Sheets).
4. Always wear protective clothing, chemical resistant
gloves, eye protection and other personal protective
equipment as recommended by the chemical manufac-
turer.
5. Properly dispose of chemical containers, unused
chemicals and chemical solution.
Precautions for Removing or Adjusting Spray System Components
1. Stop the vehicle and set the parking brake.
2. Shut off the vehicle’s engine and remove the key
from the ignition switch.
3. Disengage all power and wait until all moving parts
have stopped.
4. Remove chemicals from pump, hoses and other
spray components. Thoroughly neutralize and rinse
spray system before loosening or removing any spray
system component(s).
5. Make sure line pressure is relieved before loosening
any system component (e.g. spray valves, spray system
hose).