Service Manual

Multi Pro 5800 Page 6 − 33 Electrical System

Operator Advisories

If one or more Toro Electronic Controller (TEC) inputs

are not in the correct position to allow certain machine

operations, or are malfunctioning, an audio alarm will

sound and an Operator advisory will appear on the Info-

Center Display (Fig. 39). Typically, an advisory can be

eliminated with a change in machine controls by the op-

erator. For example, if the operator attempts to start the

engine when the traction pedal is depressed, an adviso-

ry is identified on the InfoCenter Display that the traction

pedal needs to be in neutral. The advisory screen will

clear automatically after a few seconds or can be

cleared from the display manually by pressing any of the

InfoCenter buttons. An advisory will not be recorded in

any fault log. The following table explains each advisory

in more detail.

The InfoCenter Display is also used during the flow me-

ter Calibration and Speed Sensor Calibration process to

display a variety of instructions and advisories (see

Spray System Chapters in this manual for additional in-

formation).

In addition to Operator advisories, a machine fault may

occur during machine operation. The InfoCenter Dis-

play will display the current machine fault code and log

the specific fault information (see Faults Codes in this

chapter).

1. Advisory number/code 2. Advisory description

Figure 39