Service Manual

Multi Pro 5800Page 8 − 20GeoLink Spray System

Record Job Details Menu

The job menu (Fig. 20) provides access to the following

sub−menus and screens:

Select Job (existing)

Create Job (new)

Configure Job Regions

Record Job Details

Clear Job Data

Data Exchange Menu

Figure 20

1. Job menu icon

2. Select job icon

3. Create job icon

4. Configure job regions

icon

5. Record job details icon

6. Clear job data icon

7. Data exchange menu

icon

Compass Calibration

Accuracy of the GeoLink guidance feature is dependant

on information from the system compass located in the

GPS antenna (AGI−4). Start the five step compass cali-

bration wizard to calibrate the system compass by open-

ing the receiver calibration menu icon and selecting

compass (Fig. 21).

NOTE: See Calibrating the Compass in the Adjust-

ments section of this chapter for additional information.

Figure 21