Service Manual

Multi Pro 5800 Page 7 − 27 ExcelaRate Spray System
Operator Advisories
If one or more Toro Electronic Controller (TEC) inputs
are not in the correct position to allow certain machine
operations, or are malfunctioning, an audio alarm will
sound and an Operator advisory will appear on the Info-
Center Display (Fig. 27). Typically, an advisory can be
eliminated with a change in machine controls by the op-
erator. For example, if the operator attempts to start the
engine when the traction pedal is depressed, an adviso-
ry is identified on the InfoCenter Display that the traction
pedal needs to be in neutral. The advisory screen will
clear automatically after a few seconds or can be
cleared from the display manually by pressing any of the
InfoCenter buttons. An advisory will not be recorded in
any fault log. See Chapter 6 − Electrical System in this
manual or the machine Operator’s Manual for the com-
plete list of operator’s advisories. The following table ex-
plains each spray system operator advisory specific to
machines with ExcelaRate spray systems.
1. Advisory number/code 2. Advisory description
Figure 27
1
2
PRESS ANY KEY
TO START PUMP
TURN BOOMS OFF
202
Advisory Advisory Description Recommended Action
202 Pump start prevented − Boom active Set master boom switch to OFF
position
203 Pump Start Prevented −
Operator out of seat and parking brake not engaged
Operator return to seat or set parking
brake
205 Pump Start Prevented − Engine starting Set spray pump enable switch to OFF
position
206 Pump Turned OFF − Operator not in seat Operator return to seat or set parking
brake
402 Tank Low Volume Alert Prepare to discontinue spraying as the
volume in the spray tank has dropped
below the alert level set by the user
403 Rinse Pump ON (optional clean tank rinse kit) Set optional clean tank rinse pump
switch to OFF position
802 Booms Turned Off − Vehicle speed too low for automatic mode
function
Increase vehicle speed before at-
tempting ExcelaRate (automatic appli-
cation−rate) spray system control, or
switch to Manual spray system control