Service Manual

Multi Pro 5800−DPage 3 − 10Kubota Diesel Engine
Removal (Fig. 5)
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Remove the rear undercarriage shroud from the ma-
chine (see Undercarriage Shrouds in Chapter 9 − Chas-
sis in this manual).
3. Support muffler from below to prevent it from falling.
4. Remove exhaust system components as required.
During removal, note location and orientation of fasten-
ers, rubber hangers, clamps and brackets.
5. Locate and discard gasket between exhaust pipe
and header if exhaust pipe is disconnected from header.
Clean gasket surfaces on engine exhaust manifold and
exhaust pipe.
Installation (Fig. 5)
1. If exhaust pipe was removed from engine, use a new
gasket and install exhaust pipe and fasteners finger
tight.
2. Install all remaining exhaust system components in-
cluding hangers, clamps and brackets finger tight.
3. Tighten exhaust system components in the following
order:
A. Tighten fasteners securing exhaust pipe to ex-
haust header.
B. Tighten exhaust system hanger and bracket fas-
teners. DO NOT tighten muffler clamps at this time.
C. Position the tailpipe so the outlet is parallel to the
ground and tighten muffler clamps.
4. Install the rear undercarriage shroud to the machine
(see Undercarriage Shrouds in Chapter 9 − Chassis in
this manual).