Service Manual

Multi Pro 5800−GPage 4 − 14Kubota Gasoline Engine
Radiator
Figure 9
1. Console assembly
2. Seat belt bracket assembly (2)
3. Carriage screw (12)
4. Flange nut (16)
5. Flange head screw (4)
6. Radiator
1
2
2
3
3
4
4
4
5
5
6
Removal
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Remove the seats and hinged seat panels from the
seat box (see Seats in Chapter 9 − Chassis in this manu-
al).
3. Remove the undercarriage shrouds from the ma-
chine (see Undercarriage Shrouds in Chapter 9 − Chas-
sis in this manual).
CAUTION
Do not open radiator cap or drain coolant if the
radiator or engine is hot. Pressurized, hot cool-
ant can escape and cause burns. Ethylene−gly-
col antifreeze is poisonous. Dispose of coolant
properly or store it in a properly labeled contain-
er away from children and pets.
4. Drain coolant from radiator (see machine Operator’s
Manual). The coolant drain valve is located under the
passenger seat, in the lower right corner of the radiator.
5. Loosen hose clamps that secure the upper and lower
radiator hoses to the radiator and disconnect the hoses
from the radiator.
6. Loosen hose clamp that secures overflow hose to ra-
diator cap flange. Remove overflow hose from radiator.
7. Remove carriage screws and flange nuts that secure
seat belt bracket assemblies to seat box and remove
both bracket assemblies from machine (Fig.9).
8. Remove fasteners that secure console assembly to
seat box (Fig. 9). Carefully pivot console assembly rear-
ward and to the right to allow radiator access. Take care
to not damage the wire harness or throttle cable. Sup-
port console to prevent it from shifting, falling, or hang-
ing from wire harness or throttle cable.