Service Manual

Multi Pro 5800Page 7 − 16ExcelaRate Spray System
DISPLAY
The Display settings (Fig. 14) are discussed in Chapter
6 − Electrical System in this manual.
BOOM WIDTH
The Boom Width settings entered on this screen are
used by the spray system to calculate the area sprayed.
The boom width settings (Fig. 15) are accessed from
the settings screen and provide access to the following
display settings:
Left: The width of left boom installed.
Center: The width of center boom installed.
Right: The width of right boom installed.
NOTE: The Boom Width screen may be PIN protected.
See Settings Screen > Display > Protected Menus in
Chapter 6 − Electrical System in this manual or the ma-
chine Operator’s Manual and Software Guide for addi-
tional information.
Access the various items by pressing buttons 1 or 2 to
highlight the desired item and button 3 or 4 to adjust the
setting.
Return to the previous screen by pressing button 5
RESET DEFAULTS
The Reset Defaults screen is discussed in Chapter 6 −
Electrical System in this manual.
GEOLINK
Use the GeoLink screen to activate the GeoLink spray
control system. Turn ON the GeoLink setting only if you
have the optional GeoLink spray system installed on the
machine. See Chapter 8 − GeoLink Spray System in this
manual for additional service information.
1
2
3
4
5
6
1. Button 1
2. Button 2
3. Button 3
4. Button 4
5. Button 5
6. Display settings
Figure 14
1
2
3
4
5
6
1. Button 1
2. Button 2
3. Button 3
4. Button 4
5. Button 5
6. Boom width settings
Figure 15