Service Manual

Multi Pro 5800−GPage 4 − 18Kubota Gasoline Engine
Figure 12
1. Access panel
2. Seat base − front
3. Washer head screw (20)
4. Flange nut (20)
5. Seat base − RH
6. Support strap (2)
7. Cross member
8. Engine shroud
9. Cross member support − RH
10. Cross member support − LH
11. Seat base − LH
12. Fuse block
11
1
2
3
3
3
3
3
3
4
4
4
4
5
6
6
7
8
9
10
12
8. Disconnect the breather hose from the engine valve
cover.
9. Remove exhaust system from engine (see Exhaust
System Removal in this chapter).
10.Depending on the type of engine hoist you use, you
may wish to remove the R.O.P.S. bar from the machine.
11. Remove spray tank (see Spray Tank in the Spray
System chapters in this manual).
12.Remove engine shroud from back of seat base
(Fig. 12).
13.Label the wire harness connectors at the relays and
ground terminal block attached to the left side seat base
panel.
14.Remove the fuse block from the mounting bracket on
the left side seat base panel.
15.Remove seat base panels (left side, right side and
front), rear cross member and cross member supports
from machine (Fig. 12).
CAUTION
Hydraulic pump assembly weighs approximate-
ly 72 pounds (33 kg). Make sure that pump as-
sembly is well supported (from above or below)
during engine removal.
16.Detach hydraulic pump assembly from engine (see
Piston (Traction) Pump in Chapter 4 − Hydraulic System
in this manual).
NOTE: Separate the Yanmar engine wire harness from
the machine wire harness and remove the engine with
the Yanmar engine wire harness connected to the indi-
vidual engine electrical components.