Service Manual

Multi Pro 5800Chassis Page 9 − 30
Disassembly (Fig. 22)
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Remove five (5) washer head screws (item 2) that
secure each cover to console assembly and remove
console assembly covers from machine.
3. Remove components from console assembly as
needed. Record the location of any wire harness clips.
clamps or anchors.
NOTES:
USB Socket: Install with cap hinge to top, grey wire to
top terminal and black wire to bottom terminal.
Throttle control (diesel engines): Pass throttle cable
through grommets in console frame and console
base. Secure throttle cable to R−clamp on engine
shroud. Make sure throttle cable swivel at engine ro-
tates freely and that throttle arm at engine travels ful-
ly from stop to stop.
Console frame: Install as far to right as possible with-
out interfering with passenger seat movement
(open/close).
Assembly (Fig. 22)
1. Install all removed components to console assem-
bly. Secure wire harness to machine as noted during dis-
assembly.
2. Position covers to console assembly. Make sure that
wire harness and throttle control cable (diesel engines)
are routed correctly through cover openings.
3. Secure each cover to console assembly with five (5)
washer head screws (item 2).
1. InfoCenter display
2. Speed lock switch
3. Throttle control
4. Right boom lift switch
5. Center boom switch
6. RH boom switch
7. Master boom switch
8. LH boom switch
9. Left boom lift switch
10. Pump switch
11. Agitation switch
Figure 23
1
2
3
4
5
6
7
8
9
10
11