Service Manual

Turret Body Service
Disassembly (Fig. 36)
IMPORTANT: Make sure to remove and neutralize
chemicals
from spray components before disas-
sembly. Wear protective clothing, chemical resist-
ant gloves, and eye protection during repair.
1. Pull e–clip from body and slide plug with o–ring from
body
.
2. Disassemble turret body using Figure 36 as a guide.
3. Discard all removed seals, gaskets, o–rings, and di-
aphragms.
Assembly (Fig. 36)
NOTE: Coat all o–rings with vegetable oil before instal-
lation to reduce the chance of
damage during assembly.
1. Replace all removed seals, gaskets, o–rings, and di-
aphragms.
2. Assemble turret body using Figure 36 as a guide.
A. The turret (item 8) end with slightly larger bore
and detent grooves needs to be orientated toward
detent posts on body (item 4) (Fig. 37).
B. Make sure to align notch on plug (item 10) with
groove in body (item 4) as plug is installed.
C. Install e–clip (item 5) into body to secure assem-
bly.
1
2
3
6
4
5
11
10
12
14
13
15
8
7
9
17
16
18
6
Figure 36
1. Upper clamp 10. Plug
2. O–ring 1
1. Nozzle
3. Pivot pin 12. Nozzle
cap
4. Body 13. O–ring
5. E–clip 14. Seal
6. Gasket (3 used) 15. Screw
7. Dust cap (2 used) 16. End
cap
8. Turret 17. Diaphragm
9. O–ring 18. Hose
barb
2
1
3
2
Figure 37
1. Body 3. Detent groove
2. Detent post
Spray
System
Multi Pro 5700–D
Page 6 – 37
Spray System