Operator's Manual

13
SET-UP INSTRUCTIONS
9. Assemble bypass Hose to Boom bypass post
using Fork (See FIG. 8, page 12). Bypass Hose
is routed between the left fender and the left side
of the Tank Saddle. Route through the large slot
in the Boom Valve Bracket to the left of the Boom
Valve.
10. Assemble agitation Valve to Boom Valve
Bracket using one (1) 5/16-18 x 3/4 Flange Bolt
and one (1) 5/16-18 Flange Nut. (See FIG. 9)
11. Assemble foam to Valve Support Bracket.
Cut 2" from foam and adhere to left side of
Support Bracket and remaining foam to right
side. (See FIG. 10)
FIG. 9
FIG. 10
FIG. 11
12. Tilt Valve Support onto agitation and Boom
Valves and attach to Boom Mount Bracket with
Supply Hose R-Clamp using two (2) 1/4-20 x 3/4
Flange Bolts and (2) 1/4-20 Flange Nuts. (See
FIG. 11)
2061-5600
2060-5600
2062-5600
13. Assemble center Boom to Boom Mounting
Brackets. Place Spacer Tube between tabs on
Center Boom. Attach center Boom and Boom
Straps to Boom Mounting Brackets using two (2)
1/2 x 2 3/4" Cap Screws; attach Boom Support
Straps to Boom Mounting Brackets using two (2)
1/2" x 1 1/4" Cap Screws with four (4) 1/2 Locknuts
and four (4) 1/2" Flat Washers. (See FIG. 12)
FIG. 12
1801-5600
1. Spacer Tube 3. Boom Mounting Brackets
2. Main Frame Tube 4. Boom Mounting Strap
1. Agitation Valve 2. Boom Valve Bracket
1. Valve Support Bracket 2. 2" Foam Piece
1. Boom Mount Bracket 3. R-Clamp
2. Valve Support 4. Agitation Valve
2
1
1
2
2
2
4
4
3
1
NOTE: If installing the "Enclosed Boom"
option in place of Standard Boom, skip steps
13 and 15 thru 30 and refer to the instructions
furnished with that kit before continuing step
31.
2
1
4
3