Operator's Manual

26
BEFORE SPRAYING
41442 PTO PUMP
INITIAL SYSTEM SET-UP:
1. Fill the Tank with clean, clear water and open
the Suction Line Valve.
IMPORTANT: The pump will be damaged if it is
activated before it is completely filled with
liquid. Be certain the suction line valve is open
and liquid has reached the pump.
2. Take the vehicle out of gear and set the parking
brake. Start the Vehicles engine and set throttle
to represent the desired spraying speed.
3. Engage PTO Drive.
4. Open Ratchet Valve to begin spraying water
from the booms.
5. Adjust the Pressure Adjust Valve to the desired
spray pressure.
NOTE: This entire procedure should be
repeated whenever changing operating
pressure, nozzles, speed, chemical, etc.
FILLING THE SOLUTION TANK:
WARNING
CHEMICALS ARE HAZARDOUS AND CAN
CAUSE PERSONAL INJURY!
Carefully read the directions printed on
the chemical manufacturers labels
before handling chemicals. Instructions
on chemical manufacturers container
labels, regarding mixing proportions,
should be read and strictly followed.
Keep spray material from skin. If spray
material comes in contact with body,
wash it off immediately with clean water
and detergent.
Always wear goggles and other
protective equipment as recommended
by the Chemical Manufacturer.
FILL THE FRESH WATER WASH TANK
NOTE: Fill Fresh Water Wash Tank with clean
water only. Check to assure tank is full before
each operation.
In case of chemical contact with skin or eyes, a
fresh water wash tank has been installed on the
Tank Saddle.
1. Turn Tank Spigot to on position. See FIG. 4.
2. Hold contaminated area directly under water
stream.
FIG. 19
1. Fresh Water Wash Tank 2. Tank Spigot
1
2
IMPORTANT: Do not add chemical to Tank until
just before use. The concentrate should not be
poured into an empty Tank. Fill Tank about one-
half full with clean, clear water, add chemical
concentrate and finish filling Tank with water.
Follow the chemical manufacturers instructions
for mixing spray solution to obtain desired
application rate.