Operator's Manual

6
20
40
60
80
100
30
50
70
90
10
psig
F
U
S
E
F
U
S
E
F
U
S
E
PRESSURE
ADJUST
MG
RAVEN
ON
ON
OFF
OFF
BOOM 1 BOOM 2 BOOM 3
INDUSTRIES INC.
MASTER
Z
E
R
O
FIG. 3
1. Master on/off Switch 3. Pressure Adjust Switch
2. Individual on/off
Switches
A. Pressure Adjust Switch: Hold to
INCREASE or DECREASE spraying pressure to
desired level.
B. Master ON/OFF Switch: Activates all three
Boom Valves to control the flow of spray solution
to the Boom sections.
C. Individual Boom ON/OFF Switches: Allows
selection of individual Boom sections and controls
the flow of spray solution to left (Boom #1), center
(Boom #2) or right (Boom #3) Booms.
IMPORTANT! Be certain the Suction Line Valve
is open and liquid has reached the Pump
before the Pump is activated. The Pump will be
damaged if it is allowed to run dry!
AGITATOR VALVE: Opens and closes the By-
Pass Line to activate, adjust or stop the agitation of
the spray solution in the Tank. The Agitator Valve
must be OPEN when the pump is being used.
FIG. 2
1. Suction Line Valve 2. Agitator Valve
(Open) (Open)
ELECTRIC SPRAY CONTROL SYSTEM: Controls
the pressure and flow of spray solution to the
Boom sections. See FIG. 3.
CONTROLS
NOTE: "Right", "Left", "Front" and "Rear" are
referenced while seated in the operator's
position.
SUCTION LINE VALVE: Opens and closes the
Suction Line, which draws spray solution from the
Tank to the Pump. The Valve is OPEN when the
lever is positioned as shown in FIG. 2.