Service Manual

Multi Pro 5800Page 1 − 2Safety
Safety Instructions
The Multi Pro 5800 Turf Sprayer is designed and tested
to offer safe service when operated and maintained
properly. Although hazard control and accident preven-
tion are partially dependent upon the design and config-
uration of the machine, these factors are also
dependent upon the awareness, concern and proper
training of the personnel involved in the operation, trans-
port, maintenance and storage of the machine. Improp-
er use or maintenance of the machine can result in injury
or death. To reduce the potential for injury or death,
comply with the following safety instructions.
WARNING
To reduce the potential for injury or death, com-
ply with the following safety instructions.
Before Operating
1. Read and understand the contents of the Operator’s
Manual before starting and operating the machine. Be-
come familiar with the controls and know how to stop the
machine and engine quickly. Additional copies of the
Operator’s Manual are available on the internet at
www.Toro.com.
2. Keep all shields, safety devices and decals in place.
If a shield, safety device or decal is defective, illegible
or damaged, repair or replace it before operating the
machine. Also tighten any loose nuts, bolts or screws to
ensure machine is in safe operating condition.
3. Various safety interlocks incorporated into the sys-
tem prevent the engine from starting unless the follow-
ing conditions are met:
S The spray pump enable switch is in the OFF
position
S If an optional tank rinse kit is installed, the rinse
pump enable switch is in the OFF position
S The seat switch is depressed indicating an Op-
erator is present, or the parking brake is engaged
S The neutral switch indicates the traction pump
is in neutral
NOTE: All of the interlock switches must be functioning
and adjusted correctly for the engine to start (see Chap-
ter 6 − Electrical System in this manual for switch adjust-
ment and testing information).
4. Since diesel fuel is flammable, handle it carefully:
A. Store fuel in containers specifically designed for
this purpose.
B. Do not remove machine fuel tank cap while en-
gine is hot or running.
C. Do not smoke while handling fuel.
D. Fill fuel tank outdoors and only to within an inch of
the top of the tank, not the filler neck. Do not overfill
the fuel tank and wipe up any spilled fuel.