Service Manual

Multi Pro 5800 ChassisPage 9 − 9
4. Install greased outer bearing cone, washer and
slotted hex nut onto spindle shaft.
5. Rotate the wheel hub by hand and torque the slotted
hex nut from 75 to 180 in-lb (8.5 to 20.3 N−m) to seat
bearings. Loosen nut until it is away from washer and
hub has end play. Finally, tighten slotted hex nut from 15
to 20 in−lbs (1.7 to 2.2 N−m) while rotating hub.
6. Install cotter pin through spindle shaft hole. Install
dust cap to hub.
7. Install front wheel assembly (see wheel installation
in this chapter).
8. Lower machine to ground.