Service Manual

Multi Pro 5800Page 6 − 92Electrical System

Audible Alarm

The audible alarm sounds to notify the operator when a

machine problem exists. Electrical current for the alarm

is provided as an output from the TEC. The audible

alarm is located in the center of the instrument panel

(Fig. 133).

Testing

1. Park machine on a level surface, stop engine and en-

gage parking brake. Remove key from ignition switch.

2. Locate alarm and disconnect machine wire harness

from alarm.

IMPORTANT: Make sure to observe polarity on the

alarm terminals when testing. Damage to the alarm

may result from an improper connection.

3. Connect 12VDC power to the terminals as shown

(Fig. 134). The alarm should sound. Replace the alarm

if necessary.

4. If the alarm tests correctly and a circuit problem still

exists, check wire harness (see Electrical Schematic

and Wire Harness Drawings in Appendix A − Foldout

Drawings in this manual).

5. Reconnect machine wire harness to alarm.

1. Instrument panel 2. Audible alarm

Figure 133

1. Top view

2. Bottom view

3. Positive (+) terminal

4. Negative (−) terminal

Figure 134