Service Manual

Multi Pro 5800 Page 6 − 19 Electrical System
Protected Menus
Various InfoCenter menus/screens/settings can be pro-
tected so a four digit PIN (Personal Identification Num-
ber) is required prior to accessing the menu/screen or
adjusting the setting (Fig. 22). Any combination of the
following menus/screens/settings can be selected for
protection:
All Menus: If selected, all menus/screens/settings
other than the Operator Information Screen and the
Spray Area Screens are protected.
Calibration: If selected, all calibration menus are pro-
tected.
Service: If selected, the service timer reset function
is protected.
Set Rates: If selected, application rate adjustment
and boost% adjustment is protected.
Boom Width: If selected, modifying the boom width
setting is protected.
Reset Defaults: If selected, the InfoCenter default
setting reset function is protected.
PIN Settings
Use of a PIN allows the ability to password protect ac-
cess to all screens other than the Operators Information
Screen and the Spray Area Screens. Use the PIN set-
tings screen for turning the PIN protection feature ON or
OFF (PIN ENTRY) or to change the current PIN (PIN
CHANGE) (Fig. 23). See the machine Operator’s Manu-
al or Software Guide for additional information.
IMPORTANT: If PIN use is chosen (PIN ENTRY ON),
and a custom PIN is entered, make sure to record
the PIN for future InfoCenter Display access. If PIN
reset is necessary (e.g. PIN has been forgotten),
contact your Authorized Toro Distributor.
Mute
The Mute setting controls the InfoCenter audio signal
(ON/OFF).
NOTE: Setting the mute audio indicator to ON mutes
the audio signal for the InfoCenter only—not the audio
warning alarm for the machine.
1. Button 1
2. Button 2
3. Button 3
4. Button 4
5. Button 5
6. Protected menus
Figure 22
1
2
3
4
5
6
Figure 23
1. Button 1
2. Button 2
3. Button 3
4. Button 4
5. Button 5
6. PIN settings
1
2
3
4
5
6