Installation Instructions

ManualsBrandsToro ManualsSprayersEnclosed Boom Mount, Workman 200 Spray System

Form No. 3352-115

Page 15

Register your product at www.toro.com Original Instructions (EN)

Print Date 4/19/05

CENTER BOOM MOUNT ASSEMBLY:

1. Assemble Boom Mount onto the Center Boom as

per FIG. 4 using the (6) 1/2" x 3" hex hd. cap

screws and lock nuts. FIG. 4a.

FIG. 4a

FIG. 4b

1. Boom Center Section 2. Boom Mount

2. Assemble the (2) straight Castor Mounts into

Center Boom section, using (4) 1/2" x 3" carriage

hd. bolts and lock nuts, ensuring that bolt heads

are on the “hood opening” side. Assemble (2)

Wheels onto (2) Castor Forks with the long shafts

using (2) 3/4" O.D. x 6" bushings and (2)

1/2" x 7-1/2" hex hd. cap screws. Assemble

Castor Forks onto Castor Arms using a spring and

cotter pin on each castor. (Refer to Page 14)

3. The Boom Mount has several holes to

accommodate different sprayers. To determine the

correct mounting holes to use, ensure that the

Center Boom and the sprayer are on a level

surface approximately as the Boom will be

attached. Block up the Center Boom Section so

that the appropriate holes align.

The holes used to attach the Boom Mount to the

Boom Mount Assemblies should be as follows:

MULTI-PRO

®

1200/1250 - Align the inner holes of

the Boom Mount with the matching holes on the

Boom Mount Assemblies. Secure with (4) 1/2" x 2-

1/4" hex hd. cap screws and lock nuts. (FIG. 4a)

MULTI-PRO

®

5600 - Align the outer holes of the

Boom Mount with the matching holes on the Boom

Mount Assemblies. Secure the two bottom holes

with 1/2" x 1-1/4" hex hd. cap screws and lock

nuts. Align the Cross Support Angle with the upper

set of holes in the Boom Mount and secure with

two

1/2" x 1-1/4" hex hd. cap screws. See FIG. 4a.

WORKMAN

®

SPRAY SYSTEM - Align the bottom

hole in Boom Mount Angles with the seventh and

tenth holes from the bottom on the Boom Mount.

Secure with (4) 1/2" x 1-1/4" hex hd. cap screws

and lock nuts. (FIG. 4b)

NOTE: When set up the Boom should be level

from front to back when the sprayer has half a

tank of water. If the Boom is not level the Boom

Mount should be moved up accordingly.