Service Manual

8. Inspect center plate for cracks and damage. Replace
center plate if the retaining ring groove has more than
15% of its edges damaged due to nicks, rounding,
cracks, or dents (Fig. 60 and 61).
UNDAMAGED
GROOVE EDGES
Figure 60
DAMAGED
GROOVE EDGES
Figure 61
9. Inspect reduction shaft:
A. Inspect reduction shaft for wear or damage. If
O.D. of needle bearing area is less than .864” (21.95
mm) or .982” (24.95 mm),
replace the reduction
shaft.
STD. O.D. 0.984” (25 mm)
Reject O.D. 0.982” (24.95 mm)
STD. O.D. 0.866” (22 mm)
Reject O.D. 0.864” (21.95 mm)
Figure 62
Drive Train Page 7 – 40 Multi Pro 1200/1250