Service Manual

Rev. C
Multi Pro 1200/1250Page 7 -- 22Drive Train
Stub Axle and Driveshaft
1. Lug nut (5 used per wheel)
2. Flange head screw
3. Wheel assembly
4. Brake drum
5. Stub axle
6. Lock washer (5 used per wheel)
7. Drive stud (5 used per wheel)
8. Cap screw (4 used per wheel)
9. Lock washer (4 used per wheel)
10. Brake assembly
11. Brake cable clip
12. Axle housing
13. Flange head screw (3 used per wheel)
14. Outer bearing cone
15. Outer bearing cup
16. Spacer
17. Bearing spacer
18. Inner bearing cup
19. Inner bearing cone
20. Bearing seal
21. End yoke
22. Flat washer
23. Flange lock nut
24. Yoke strap (2 used per yoke)
25. Bolt (4 used per yoke)
26. Driveshaft assembly
27. Lock nut (2 used per driveshaft)
28. Cap screw (2 used per driveshaft)
29. Hardened washer (2 per driveshaft)
30. Parking brake cable
Figure 21
45 to 65 ft--lb
(61to88N--m)
FRONT
RIGHT
4
11
6
7
8
9
12
10
5
1
2
3
30
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
Anti--seize
Lubricant
13
220 to 250 ft--lb
(298 to 339 N--m)
200 to 250 in--lb
(23to28N--m)
Loctite #242
Loctite #242
40 to 60 ft--lb
(54to81N--m)
Loctite #680
75 ft--lb
(101 N--m)
Removal (Fig. 21)
1. Parkmachineonalevelsurface,stopengine,andre-
move key from the ignition switch.
2. Chock front wheels. Raise rear wheel using a jack or
hoist (see Jacking Instructions in Operator’s Manual).
Block rear of machine.
3. Loosen and remove lug nuts. Remove rear wheel.
Remove brake drum (see Rear Wheels and Brakes in
Service and Repairs Section of Chapter 8 -- Chassis).
NOTE: Looseningdriveshaftattransaxlewillalloweas-
ier driveshaft removal from end yoke.
4. Remove the straps securing driveshaft bearing
cross to the end yoke, then disconnect driveshaft from
the end yoke.
5. Loosenflange lock nut that secures end yoke to stub
axle. Remove flange lock nut, flat w asher, and flange
head screw. Pull end yoke from stub axle.
6. Carefully slide stub axle from axle housing.
7. To remove driveshaft from transaxle, loosen and re-
move lock nuts, cap screws, and hardened washers se-
curing driveshaft to splined axle shaft of transaxle. Slide
driveshaft outward and remove from transaxle.
8. To remove axle housing from machine:
A. Remove brake assembly from axle housing (see
Rear Wheels and Brakes in Service and Repairs
Section of Chapter 8 -- Chassis).
B. Remove three(3)flangehead screws thatsecure
axle housing to machine frame. Remove axle hous-
ing.