Service Manual

Multi Pro 1200/1250 ChassisPage 8 – 25

Removal (Fig. 20)

1. Park machine on a level surface, stop engine, and re-

move key from the ignition switch.

2. Disconnect negative (–) cable and then positive (+)

cable from battery (see Operator’s Manual).

3. Remove seat assembly by tilting seat forward and

removing hitch pin and clevis pin (Fig. 21).

4. Remove screws that secure control panels to seat

base. Carefully place control panels into seat base

openings.

5. Remove knob from shift lever.

6. Remove eight (8) flange head screws that fasten

seat base to machine. During screw removal, locate and

remove washers and spacers. The two (2) screws di-

rectly behind the front wheels are secured with flange

nuts (Item 7).

7. Carefully lift seat base from machine.

Installation (Fig. 20)

1. Position seat base on machine.

2. Carefully pull control panels through openings in

seat base.

3. Secure seat base to machine using washers,

spacers, flange nuts, and eight (8) flange head screws.

Install all fasteners before tightening.

4. Install knob on shift lever.

5. Secure control panels to seat base.

6. Secure seat assembly to machine with clevis pin and

hitch pin.

7. Connect positive (+) cable and then negative (–)

cable to battery (see Operator’s Manual).

1. Seat assembly

2. Hitch pin

3. Clevis pin

Figure 21

Chassis