Service Manual

Multi Pro 1200/1250Chassis
Page 8 – 4
Service and Repairs
Front Wheels and Brakes
Figure 3
1. Dust cap
2. Slotted hex nut
3. Washer
4. Wheel and tire assembly
5. Wheel bearing cone
6. Wheel bearing cup
7. Wheel hub/drum
8. Lock nut (4 per wheel)
9. Front brake assembly
10. Front spindle
11. Flange head screw (4 per wheel)
12. Seal
13. Lug nut (5 per wheel)
14. Cotter pin
55 to 65 ft–lb
(75 to 88 N–m)
See text for
7
6
10
8
9
1
4
5
2
3
13
12
11
6
5
14
tightening
procedure
17 to 19 ft–lb
(23 to 25 N–m)
Removal (Fig. 3)
1. Park machine on a level surface, stop engine, and re-
move key from the ignition switch.
2. Jack front wheel off the ground (see Jacking Instruc-
tions in Operator’s Manual). Chock front and rear of oth-
er wheels.
3. Remove lug nuts and wheel assembly.
4. Carefully pry dust cap from wheel hub.
5. Remove cotter pin from front spindle.
6. Remove slotted hex nut and washer that secures
wheel hub/drum to spindle. Slide wheel hub with bear-
ings from spindle.
7. If required, disassemble wheel hub/drum:
A. Pull seal out of the wheel hub.
B. Remove bearings from both sides of wheel hub.
Clean bearings in solvent. Clean inside of the hub.
8. Inspection and service of front brakes can be com-
pleted with brake assembly on machine (see Front
Brake Service). If required, brake assembly can be re-
moved from machine as follows: