Service Manual

Jacking Instructions

CAUTION

jack stands, the machine may move or fall,

Jacking the Front End

vent the machine from moving.

Figure 1

When changing attachments, tires, or perform-

ing other service, use correct blocks, hoists,

and jacks. Make sure machine is parked on a

solid level surface such as a concrete floor.

Prior to raising machine, remove any attach-

ments that may interfere with the safe and prop-

raising of the machine. Always chock or

block wheels. Use jack stands or solid wood

blocks to support the raised machine. If the ma-

chine is not properly supported by blocks or

which may result in personal injury.

1. Set parking brake and chock both rear tires to pre-

2. Position jack securely under the A–arms, just to the

inside of the front tire (Fig. 1).

3. Jack front of machine off the ground.

1. Front jacking points

4. Position jack stands or hardwood blocks under the

Figure 2

A–arms as close to the wheel as possible to support the

1. Rear jacking points

machine.

Jacking the Rear End

1. Set parking brake and chock both front tires to pre-

vent the machine from moving.

2. Place jack securely under the rear most frame sup-

ports between the angle welds (Fig. 2).

3. Jack rear of machine off the ground.

4. Position jack stands or hardwood blocks under the

frame to support the machine.

Safety and Instruction Decals

Numerous safety and instruction decals are affixed to

the Multi Pro 1200 and Multi Pro 1250. If any decal be-

comes illegible or damaged, install a new decal. Decal

part numbers are listed in your Parts Catalog. Order re-

placement decals from your Authorized T

oro Distributor.

Safety Page 1 – 4 Multi Pro 1200/1250