Operator's Manual

23
Spray Prot Monitor
The Spray Pro monitor displays and monitors various
system performance data such as vehicle speed and
application rates. It does not control the application rate.
The monitor has an LCD screen that displays the data you
select, a selection dial, and 4 buttons for calibrating the
monitor (Fig. 27).
m–XXXX
US English CE Symbol
20
20
Figure 27
1. LCD screen
2. Selection dial
3. Reset, calibration button
4. Calibrate, calibration button
5. Decrease, calibration button
6. Increase, calibration button
7. Total area
8. Boom selection
9. Speed
10. Units of measure
11. Select units
12. Application rate
13. Sub Area
14. Width
15. Distance
16. Speed calibration
17. Sub volume
18. Total volume
19. Flowmeter calibration
20. LED
Selection Dial
The selection dial contains the following positions:
• Total area
Displays the total acres (US), hectares (SI), or sq feet
(TURF) that you have covered since you last pressed
the Reset calibration button for this setting.
• Speed
Displays the ground speed in miles per hour (if the
Units of Measure is set to US or TURF) or kilometers
per hour (if the Units of Measure is set to SI).
• Units of Measure
Displays the current measurement unit selection as
follows:
– US (United States measuring system)
– SI (metric system)
– TURF (as US but the volumes are in US gallons per
1000 sq ft instead of US gallons per acre)
• Application Rate
Displays the application rate in US gallons per acre
(US), liters pre hectare (SI), or US gallons per 1000 sq
ft (TURF).
• Sub Area
Displays the total acres (US), hectares (SI), or sq feet
(TURF) that you have covered since you last pressed
the Reset calibration button for this setting, without
affecting the Total Area display. If you press the Reset
calibration button, the Sub Volume also resets.
• Distance
Displays the distance you have traveled in feet (US and
TURF) or meters (SI) since you last pressed the the
Reset calibration button for this setting.
• Sub Volume
Displays the total volume in US gallons (US and
TURF) or liters (SI) that you have applied since you last
pressed the Reset calibration button for this setting,
without affecting the Total Volume display. If you press
the Reset calibration button, the Sub Area also resets.