Installation Instructions

8
Safety and Instruction Decals
Safety decals and instructions are easily visible to the operator and are located near any area
of potential danger. Replace any decal that is damaged or lost.
106-5081
1. Boom spray
2. Hand spray
3. Continuous variable
setting
107-8757
1. Hose reel rewind; push to engage.
Operation
Fluid under pressure can penetrate skin and cause
injury.
• Keep your body and hands away from nozzles
that eject high pressure fluid.
• Do not aim the sprayer at any person or animal.
• Make sure all fluid hoses and lines are in good
condition and all connections and fittings are
tight before applying pressure to the system.
• Use cardboard or paper to find leaks.
• Safely relieve all pressure in the system before
performing any work on it.
• Get immediate medical help if fluid is injected
into skin.
• Hot liquids and chemicals can cause burns or
other harm.
Warning
Switching from Boom Spray
Mode to Hand Spray Mode
1. Stop the machine and set the parking brake.
Driving while using the hand sprayer can cause
loss of control, resulting in injury or death. Do not
operate the hand sprayer while driving.
Warning
2. Ensure that the trigger lock on the spray gun is locked.
3. Turn the red knob on the face of the control valve to the
Hand Spray position.
4. Turn the booms off.
5. On Multi-Pro 1250 Sprayers, use the application rate
switch to adjust the application rate to the highest
setting.
6. Turn the pump on.
7. Increase the engine speed until the pressure gauge reads
150 psi and and set it at that speed.
Note: Hose reel accessories that require flows greater than
7 GPM may have reduced performance. The level of
performance experienced by the operator is dependant upon
accessory pressure required, accessory speed and other
adjustable variables. For most reasonable settings,
attachments will meet and exceed operator requirements.
Please consult you nozzle selection guide for further
information.
Important Do not use a pressure setting higher than
150 psi with the hand sprayer.
Note: Use the pressure gauge to the right of the control
valve while turning the red knob to achieve the desired
amount of pressure at hand sprayer.