Operator's Manual

INITIAL CONSOLE PROGRAMMING

Step 1

Selecting US (Acres), SI [Hectares], or TU {1,000 Sq. Ft.}

(b) Once the desired setting has been reached, momentarily depress

ENTER

to lock in your selection.

(a) Momentarily depress

until you reach the desired

setting (US, SI or TU).

The DATA display will now display SP1.

When you first turn on Console power, after all installation procedures have

been completed, the Console will flash "CAL" in the RATE display. This

means you must "calibrate" or program the Console before it can be operated.

(This is a one-time operation which does not have to be repeated. Turning

OFF the POWER ON/OFF Switch does not affect the Console memory. All

data is retained.)

SELF

TEST

for 20 seconds (data displays US.),

can be reset by depressing

The following steps must be followed:

If an entry selection error is made during steps 1,2 or 3, the Console

on Console Model 063019531. On Console Model 063017269, turn power

off, hold and power on at the same time to reset programming.

Momentarily depress

until you reach the (SP1) setting, then

momentarily depress to lock in your setting.

Step 2

Selecting SP1 & 3 (Wheel Drives, etc.) or SP2 (Radar Sensor).

NOTE: THE TORO MULTI PRO 1100 USES THE WHEEL DRIVE SETTING

(SP1), THEREFORE YOUR ENTRY SHOULD BE SP1.

ENTER

until you reach the (C-Sd) setting.

ENTER

Momentarily depress

Step 3

Note: Step 3 may be needed on some Consoles. If not continue to back of this card.

Momentarily depress to lock in your setting.

Refer to the back of this card to complete console programming.

Rev. 12/5/97 S.D.

MULTI PRO

1100