Operator's Manual

13
INITIAL SYSTEM FIELD TEST(Contd):
5. At the end of each swath sprayed, switch the
MASTER ON/OFF to OFF to shut off flow. This
also shuts off the acreage totalizer.
6. Verify acres covered and gallons used.
FILLING THE SOLUTION TANK:
DANGER
Chemicals can be hazardous!
 Read carefully the directions printed
on the chemical manufacturers labels
before handling chemicals. Instructions
on chemical manufacturers container
labels, regarding mixing proportions,
should be read and strictly followed.
 The concentrate should not be
poured into an empty Tank: fill Tank
about 3/4 full with clean, clear water, add
chemical concentrate SLOWLY. With full
agitation finish filling Tank with water.
 Keep spray material from skin. If
spray material comes in contact with
body, wash it off immediately with clean
water and detergent.
 Always wear goggles and other
protective equipment as recommended
by the Chemical Manufacturer.
IMPORTANT! DO NOT add chemical to Tank
until just before use. Follow the chemical
manufacturers instructions for mixing spray
solution to obtain desired application rate.
FILL THE CLEAN WATER WASH TANK.
NOTE: Fill Clean Water Wash Tank with clean
water only. Check to assure tank is full before
each operation.
In case of chemical contact with skin or eyes, a
fresh water wash tank has been installed on the
R.H. side of the vehicle.
BEFORE SPRAYING
FIG. 5
1. Clean Water Wash Tank 2. Tank Spigot
1. Turn Tank Spigot to on position. See FIG. 5.
2. Hold contaminated area directly under water
stream.
1123