Operator's Manual

12
BEFORE SPRAYING
7. Verify area covered and volume used.
FILL THE FRESH WATER WASH TANK:
In case of chemical contact with skin or eyes,
refer to the Chemical Manufacturer's label for
instructions on seeking medical attention. A
fresh water wash tank has been installed on
the right side of the Vehicle.
NOTE: Fill Fresh Water Wash Tank with clean
water only. Check to assure tank is full before
each operation.
1. Turn Tank Spigot to on position. See FIG. 1.
FIG 1
1. Clean Water Wash Tank 2. Tank Spigot
2. Hold contaminated area directly under water
stream and flush thoroughly.
3. Turn Tank Spigot to "OFF" position.
FILLING THE SOLUTION TANK:
CAUTION
Chemicals can be hazardous! Read
carefully the directions printed on the
chemical manufactrurer's labels before
handling chemicals. Instructons on
chemical manufacturer's container labels,
regarding mixing proportions, should be
read and strictly followed. The
concentrate should not be poured into an
empty Tank: Fill Tank about one-half full
with clean, clear water, add chemical
concentrate and finish filling Tank with
water.
Keep spray material from skin. If spray
material comes in contact with body,
wash it off immediately with clean water
and detergent.
Always wear goggles and other protective
equipment as recommended by the
Chemical Manufacturer.



IMPORTANT: FOLLOW THE CHEMICAL
MANUFACTURER'S INSTRUCTIONS FOR
MIXING SPRAY SOLUTION TO OBTAIN
DESIRED APPLICATION RATE. DO NOT ADD
CHEMICAL TO TANK UNTIL JUST BEFORE
USE. THE CONCENTRATE SHOULD NOT BE
POURED INTO AN EMPTY TANK; FILL TANK
ABOUT ONE-HALF FULL WITH CLEAN, CLEAR
WATER. WITH AGITATION ON, ADD
CHEMICAL CONCENTRATE AND FINISH
FILLING TANK WITH WATER.
1. Refer to "Operation Section".
2039