Operator's Manual
7
USING THE SPRAYER:
IMPORTANT: Check all of your equipment...
Make sure that all components are clean,
including the Tank, Pump, Control Valve,
Solenoids, Strainers, Check Valves, Hoses,
Nozzles, Spray Tips, and Suction Line Strainer.
1. Start the vehicle engine and select the proper
gear. Position the throttle to the desired operating
RPM, as determined by RPM/Seed ratio decal
located on the front dash panel above the
Tachometer.
2. Engage the Pump and use the Main Shut off
Lever and individual Boom Shut off Levers to
control Boom sections while spraying.
IMPORTANT! While operating the
Sprayer:
Do not overlap areas that have been sprayed
previously.
OPERATION
In case of chemical contact with skin or eyes, a
fresh water wash tank has been installed on the
R.H. side of the vehicle.
1. Turn Tank Spigot to on position. See FIG. 4.
2. Hold contaminated area directly under water
stream.
Pressure Adjust Knob until the original pressure
setting is reached. Turn Left Boom back on.
7. With all Boom ON, switch Center Boom to
OFF and adjust the Center Booms By-Pass
Pressure Adjust Knob. Turn Center Boom back
on.
8. With all Booms on, Switch Right Boom to
OFF and repeat this procedure for setting the
Right Booms By-Pass Pressure Adjust Knob.
Turn Right Boom back on.
To double check these settings, switch Boom
sections ON and OFF. Verify that the pressure
does not change at the gauge.
NOTE: This entire procedure should be
repeated whenever changeing to a different
operating pressure.
FILL THE FRESH WATER
WASHTANK
NOTE: Fill Fresh Water Wash Tank with clean
water only. Check to assure tank is full before
each operation.
FIG. 4.
1.Clean Water Wash Tank 2. Tank Spigot
CHEMICALS ARE HAZARDOUS AND CAN
CAUSE PERSONAL INJURY!
Carefully read the directions printed on
the chemical manufacturer’s labels before
handling chemicals. Instructions on
chemical manufacturer’s container labels,
regarding mixing proportions, should be
strictly followed.
Keep spray material from skin. If spray
material comes in contact with body, wash
it off immediately with clean water and
detergent.
Always wear goggles and other
protective equipment as recommended by
the Chemical Manufacturer.
CAUTION
FILLING THE SOLUTION TANK:
IMPORTANT: Do not add chemical to Tank
until just before use. The concentrate should
not be poured into an empty Tank: fill Tank
about one-half full with clean, clear water, add
chemical concentrate and finish filling Tank
with water. Follow the chemical manufacturers
instructions for mixing spray solution to obtain
desired application rate.
BEFORE SPRAYING