Service Manual

CHASSIS

3-61Floating Deck Mid-Size Service Manual

6. Insert a pin punch into the mounting tube and care-

fully drive out the bushings (Fig. 0230).

2. Inspect the caster wheel fork for wear and replace if

necessary.

3. Slide the caster wheel fork through the bushings in

the mounting tube (Fig. 0232).

Note: The inside diameter of the bushings may

collapse slightly when installed. If the caster

wheel fork does not slide into the new

bushings, ream both bushings to an inside

diameter of 1.126” (29mm).

Fig 0230 PICT-1331a

Fig 0232 PICT-1319

4. Slide the spacer(s) onto the fork (Fig. 0233).

1. Grease the inside and outside of the new bushings.

Use a hammer and ﬂ at plate to carefully drive the

bushings into the pivot tubes (Fig. 0231).

7. Clean the inside of the mounting tube.

Fig 0233 PICT-1317

Fig 0231 PICT-1333a

Castor Wheel Fork Bushing Installation